108PC All about PC story in the world | Computer , PC , Hardware , Software

Cause a blue screen with error code (2)

Is still yesterday. Yet, the end is far away. (T.T)

bluescreen

Error code Stop 0 × 00000023: FAT_FILE_SYSTEM

     Cause

        1. FAT to read or write errors that occur when the system drive, hardware problems, caused by an error control signal
        2. Fragmented (fragmentation) is severe, unreasonable file IO, Raid sofeware, anti-virus programs cause more problems

     [Address]

        1. CHKDSK, Defrag conducted
        2. Antivirus, anti-spyware removal tool, Firewall, discontinue use backup program
        3. The latest version of Service Pack (SP), the latest version of drivers for various devices

Error code Stop 0 × 00000024 or NTFS_FILE_SYSTE

     Cause

        1. Nfts.sys has been corrupted, or deleted when the generation
        2. SCSI, ATA drive compatibility errors caused by faulty hardware

     [Address]

        1. SCSI if you are using, termination for failure, check cable
        2. Event viewer system log or SCSI related error checking FASTFAT
        3. Test hardware to provide hardware diagnostics
        4. DOS mode "CHKDSK / F" in Fairushisutemuerachekku after correction
        5. NF another drive to put a system error occurs, check disk

Error code Stop 0 × 00000027: RDR_FILE_SYSTEM

     Cause

        1. Error cause is not yet clear (--;)

     [Address]

        1. Kernel memory management for potential problems, and try to add memory exchange;

Error code Stop 0 × 0000002E or DATA_BUS_ERROR

     Cause

        1. Parity system error, memory module Level2 cache, video memory errors due to injury
        2. Caused by the virus

     [Address]

        1. If you install the wrong driver, deleting the driver or roll back
        2. For there are many cases of physical injury memory after to ensure that proper access and address data memory exchange if there is a problem
        3. Crack (--;) If you installed the software, remove software

Error code Stop 0 × 00000035: NO_MORE_IRP_STACK_LOCATIONS

     Cause

        1. Device drivers, or memory problems due to poor

     [Address]

        1. MSDN technical article references

Error code Stop 0 × 0000003F or NO_MORE_SYSTEM_PTES

     Cause

        1. As a major cause of PTEs (page table entries: IO system behavior unreasonable conduct) and PTEs (memory space information) is not enough, if an error occurs that is damaged or
        2. Installing the wrong driver
        3. Block of memory needed by the software (memory block) occurs when there is not enough

     [Address]

        1. Recently installed device drivers, or remove software
        2. Storage-related software, or device driver updates

Error code Stop 0 × 0000004E: PFN_LIST_CORRUPT

     Cause

        1. Memory management Page File Number list when the injury occurred
        2. Damage memory, bad memory descriptor lists have been omitted if you run the device driver

     [Address]

        1. Implementation of hardware diagnostics provided by Patsubenda
        2. Bakkuappuyutiriti, anti-virus software, Firewall, such as release of the software filter (OFF)
        3. Microsoft entered to check the Hardware Compatibility
        4. If this error occurs occasionally, then remove the memory test from the additional memory, usually caused by poor memory

Time to quit! It may still,
And therefore that those who have some knowledge of the short sentence, please refrain.
Basically, you can debug the blue screen does not explore,
Oh, we will introduce a blue screen debugging programs. I either!
So thank you again! (I am polite)